White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

1391

Table Of Contents

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the C-Series and S-Series.

7.4.1.0 Introduced on the E-Series.

Commands

● dot1x authentication (Configuration) — enable dot1x globally.

dot1x auth-fail-vlan

Configure an authentication failure VLAN for users and devices that fail 802.1X authentication.

Syntax

dot1x auth-fail-vlan vlan-id [max-attempts number]

To delete the authentication failure VLAN, use the no dot1x auth-fail-vlan vlan-id [max-

attempts number] command.

Parameters

vlan-id

Enter the VLAN Identifier. The range is from 1 to 4094.

max-attempts

number

(OPTIONAL) Enter the keywords max-attempts then number of attempts

desired before authentication fails. The range is from 1 to 5. The default is 3.

Defaults 3 attempts

Command Modes CONFIGURATION (conf-if-interface-slot/port)

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.