White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

1621

Table Of Contents

route-map-name

Enter the name of the route-map to filter the imported routes.

NOTE: Use the route-map attribute while importing routes from the global

RTM. Route-maps allow you to filter routes at the import end based on the

matching criteria that you define in the route-map.

Defaults N/A

Command Modes

● VRF mode

● CONFIGURATION mode

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9500.

Usage

Information

It is possible to configure multiple import conditions per VRF depending on the exporting VRF.

The export-target and import-target support only the match the protocol and prefix-list options. Other

options that you configure in the route-maps are ignored.

Commands

● ipv6 route-export — exports IPv6 routes to another VRF.

match source-protocol

Specify matching source-protocol criteria while exporting or importing routes.

Syntax

match source-protocol {bgp | isis | ospf | connected | static}

Parameters

bgp Enter the keyword bgp to leak or share routes corresponding to the BGP protocol.

isis Enter the keyword isis to leak or share routes corresponding to the ISIS protocol.

ospf Enter the keyword ospf to leak or share routes corresponding to the OSPF

protocol.

connected Enter the keyword connected to leak or share connected routes corresponding

to the VRF.

static Enter the keyword static to leak or share static routes corresponding to the

VRF.

Command Modes ROUTE MAP MODE