White Papers

interface range
This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk configuration).
Using the interface range command, you can enter identical commands for a range of interface.
Syntax
interface range interface {[stack/]slot/port[/subport] | port} —
{[stack/]slot/port[/subport] | port}, interface {[stack/]slot/port[subport]
| port} — {[stack/]slot/port[subport] | port},...
Parameters
interface
{[stack/]slot/
port[subport]
| port}
— {[stack/]slot/
port[subport] |
port},
interface
{[stack/]slot/
port[subport]
| port}
— {[stack/]slot/
port[subport] |
port},...
Enter interface range and one of the interfaces and then the interface
information. Select the range of interfaces for bulk configuration. You can enter
up to six comma-separated ranges. Spaces are not required between the commas.
The ranges can include VLANs, port-channels, and physical interfaces.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the stack/slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the stack/slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
stack/slot/port[/subport] information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
stack/slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a Tunnel interface, enter the keyword Tunnel then a number from 1 to
16383.
Defaults None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Updated the error message when no ports are configured within the specified
interface range.
9.13(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P2) Introduced on the S4038-ON.
9.8(0.0P5) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
668 Interfaces