Release Notes
Table Of Contents
- Dell Networking C9010, C1048P, N20xx, and N30xx 9.14(2.9P1) Release Notes
- Document Revision History
- C9010 Hardware
- C1048P Hardware
- N20xx Hardware
- N30xx Hardware
- New in This Release
- Known Behavior
- Changes to Default Behavior and CLI Syntax
- Restrictions
- Deferred Issues
- Fixed Issues
- Known Issues
- Documentation Errata
- Installation Instructions
- Update Instructions
- Support Resources
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
*********************************************************************
Upgrade CPLD Image for all pes ? [yes/no]: yes
CPLD upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
%PE1-C1048P:0 %DOWNLOAD-6-CPLD_UPGRADE: stack-unit 0 cpld upgrade success.
%PE1-C1048P:1 %DOWNLOAD-6-CPLD_UPGRADE: stack-unit 1 cpld upgrade success.
Upgrade result :
================
%RPM0-P:CP %DOWNLOAD-6-UPGRADE: PE (0/0) CPLD upgrade response, Upgrade Success.
%RPM0-P:CP %DOWNLOAD-6-UPGRADE: PE (1/0) CPLD upgrade response, Upgrade Success.
CPLD upgrade successful for all pes.Please power cycle the system manually to take
effect.
2. Power cycle each C1048P, N20xx or N30xx PE by unplugging the power cord, waiting two minutes, and then re-plugging the
power cord.
Upgrading the FPGA on C9010 RPMs
1. Upgrade the FPGA image on the primary RPM. This operation takes about 5 minutes to complete.
EXEC Privilege mode
upgrade fpga-image booted
DellEMC# upgrade fpga-image booted
Current information for the system:
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
CP FPGA 2 1.0 2.0
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for rpm 0 [yes/no]: y
FPGA upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
2. Wait for a successful upgrade result.
Upgrade result :
================
RPM0 FPGA upgrade successful. Please power cycle the system manually to take effect.
3. If the C9010 uses a standby RPM, upgrade the FPGA image on the standby RPM:
a. Connect the C9010 console to the console port on the standby RPM and log in.
b. Upgrade the FPGA image on the standby RPM. This operation takes about 5 minutes to complete.
EXEC Privilege mode
upgrade fpga-image rpm booted
DellEMC(standby)# upgrade fpga-image booted
Current information for the system:
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
CP FPGA 2 1.0 2.0
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for rpm 1 [yes/no]: y
FPGA upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
20