White Papers

!
interface hundredGigE 1/52
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the
following steps:
1. View the configurations applied on an interface.
INTERFACE mode
show config
DellEMC(conf-if-tf-1/5)#show config
!
interface twentyFiveGigE 1/5
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2. Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
DellEMC(conf)#default interface twentyFiveGigE 1/5
3. Verify the configuration.
INTERFACE mode
show config
DellEMC(conf-if-tf-1/5)#show config
!
interface twentyFiveGigE 1/5
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
Enabling a Physical Interface
After determining the type of physical interfaces available, to enable and configure the interfaces, enter INTERFACE mode by
using the interface interface command.
1. Enter the keyword interface then the type of interface and slot/port[/subport] information.
CONFIGURATION mode
interface interface
● For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the slot/port information.
2. Enable the interface.
INTERFACE mode
362
Interfaces