White Papers

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
To configure a list of possible domain names, configure the ip domain-list command up to six times.
If you configure both the ip domain-name and ip domain-list commands, the software tries to
resolve the name using the ip domain-name command. If the name is not resolved, the software goes
through the list of names configured with the ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
● specify a domain name server with the ip name-server command
● enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related configuration, use the
show running-config resolve command.
Related
Commands
● ip domain-name — specify a DNS server.
ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
740 IPv4 Routing