White Papers

Table Of Contents
To remove a priority-group configuration in a DCB map, enter the no priority-group bandwidth
pfc command.
By default, equal bandwidth is assigned to each dot1p priority in a priority group. Use the bandwidth
parameter to configure the bandwidth percentage assigned to a priority group. The sum of the bandwidth
allocated to all priority groups in a DCB map must be 100% of the bandwidth on the link. You must
allocate at least 1% of the total port bandwidth to each priority group.
dcb-map stack-unit all stack-ports all
Apply the specified DCB map on all ports of the switch stack.
S5000
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no dcb-map stack-
unit all stack-ports all command.
Parameters
dcb-map-name
Enter the name of the DCB map.
Defaults none
Command Modes CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The dcb-map stack-unit all stack-ports all command overwrites any previous DCB maps
applied to stack ports.
Related
Commands
dcb-map creates a DCB map to configure PFC and ETS parameters and applies the PFC and ETS
settings on Ethernet ports.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name
Displays the PFC and ETS parameters configured in the specified map.
Command Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
9.3(0.0) Introduced on the FC Flex IO module installed in the MXL 10/40GbE Switch.
Usage
Information
Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and
priority-based flow control (PFC) parameters used to configure server-facing Ethernet ports. S5000
Ethernet ports are DCBx-enabled by default.
548 Data Center Bridging (DCB)