White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

651

652

653

654

655

656

657

658

659

660

Table Of Contents

Parameters

snooping Enter the keyword snooping to enable debugging of IGMP snooping.

group-address

(OPTIONAL) Enter the IP multicast group address in dotted decimal format.

interface

Enter the following keywords and the interface information:

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

● For a port channel interface, enter the keywords port-channel then a

number.

Defaults Disabled.

Command Modes EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, Z9000, and Z9500.

Usage

Information

IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This

command displays packets for IGMP and IGMP snooping.

ip igmp access-group

To specify access control for packets, use this feature.

Syntax

ip igmp access-group access-list

To remove the feature, use the no ip igmp access-group access-list command.

Parameters

access-list

Enter the name of the extended ACL (16 characters maximum).

Defaults Not configured

Command Modes INTERFACE (conf-if-interface-slot/port)