White Papers

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip pim neighbor command shown in the following example.
Field Description
Neighbor address Displays the IP address of the PIM neighbor.
Interface List the interface type, with either slot/port information or ID (VLAN or Port
Channel), on which the PIM neighbor was found.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time
until the neighbor is removed from the multicast routing table (that is, until the
neighbor hold time expires).
Ver Displays the PIM version number.
● v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode.
● 1 = default Designated Router priority (use the ip pim dr-priority
command)
● DR = Designated Router
● S = Sparse mode
Example
DellEMC# show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Prio/Mode
127.87.3.4 Te 1/16 09:44:58/00:01:24 v2 1 / S
DellEMC#
show ip pim rp
View all multicast groups-to-RP mappings.
Z9500
Syntax
show ip pim [vrf vrf-name] rp [mapping | group-address]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure
this setting on that VRF.
mapping (OPTIONAL) Enter the keyword mapping to display the multicast groups-to-RP
mapping and information on how RP is learnt.
group-address (OPTIONAL) Enter the multicast group address mask in dotted decimal format to
view RP for a specific group.
1214 PIM-Sparse Mode (PIM-SM)