White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

481

482

483

484

485

486

487

488

489

490

Table Of Contents

Important Points to Remember

● All line cards/Stack Members within a single system must have the same UFT mode profiles. This profile must match the

system UFT mode profile (the profile on the primary route processor module [RPM]/ Master Unit of the Stack).

● Apply the UFT mode configuration to the entire system when you use the CONFIGURATION mode commands. Save the

running-configuration to affect the change.

● Save the changes and reboot the system for UFT mode profiling to take effect.

hardware forwarding-table mode

Select a mode to initialize the maximum scalability size for L2 MAC table or L3 Host table or L3 Route table.

Syntax

hardware forwarding-table mode {scaled-l3- hosts | scaled-l3-routes}

Parameters

scaled-l3–

hosts

Enter the keywords scaled-l3–hosts to select the forwarding table mode for

scaling l3 host entries.

scaled-l3–

routes

Enter the keywords scaled-l3–routes to select the forwarding table mode for

scaling l3 route entries.

Defaults UFT mode 2

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version Description

9.10(0.0) Introduced on the S6100-ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.7(0.0) Introduced on the S6000, S6000-ON, and Z9500 switch..

Usage

Information

This command takes effect only after reboot.

Commands

show hardware forwarding-table mode — displays the hardware forwarding table mode in the current

boot and in the next boot.

show hardware forwarding-table mode

Display the hardware forwarding table mode in the current boot and in the next boot.