White Papers

Command Modes VLT DOMAIN (conf-vlt-domain)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the IPV6/IPV4 support on the MXL.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-routing-timeout
Configure the timeout for the software to wait before connecting to a VLT peer with a Down status. This command is applicable
for both IPV6/ IPV4.
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
Parameters
value Enter the timeout value in seconds. The range is from 1 to 65535. The default value
is 0 (no timeout).
Command Modes VLT DOMAIN (conf-vlt-domain)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the IPV6/IPV4 support on the MXL.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When the timer expires, the software checks to see if the VLT peer is now available. If the VLT peer is
not available, peer-routing is disabled on that peer.
primary-priority
Reconfigure the primary role of VLT peer switches.
Syntax
primary-priority value
Parameters
value To configure the primary role on a VLT peer, enter a lower value than the priority
value of the remote peer. The range is from 1 to 65535.
Default 32768
Command Modes VLT DOMAIN
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
After you configure the VLT domain on each peer switch on both sides of the interconnect trunk, by
default, the software elects a primary and secondary VLT peer device. To reconfigure the primary role of
VLT peer switches, use the priority command.
1204 Virtual Link Trunking (VLT)