White Papers

[vman-qos |
vman--qos-dual
number | vman-
qos-dual-fp
number ] ipv4pbr
number
The ipv6acl range must be a factor of 2.
The vman-qos-dual-fp number must be entered as a multiple of 4.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Added the keyword nlbcluster ACL.
9.4.(0.0) Added support for PBR.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the
system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks; these blocks
cannot be reallocated. The ipv4acl profile range is from 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
On the switch, there can be only one odd number of Blocks in the CLI configuration; the other Blocks
must be in factors of two. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a
configuration of 6+4+2+1 Blocks is supported.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The
ipv6acl allocation must be a factor of two (2, 4, 6, 8, 10).
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable this command, if a Policy Map containing classification rules (ACL and/or dscp/ ip-
precedence rules) is applied to more than one physical interface on the same port pipe, only a single copy
of the policy is written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number
of interfaces. For more information, refer to the IP Access Control Lists, Prefix Lists, and Route-
mapsections in the Dell Networking Operating System Configuration Guide.
Content Addressable Memory (CAM) 341