White Papers

ip-address mask
[longer-prefixes]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that
route only. Enter the keywords longer-prefixes to view routes with a common
prefix.
detail Enter the keyword detail to display the group index ID used by the ecmp routes
in the CAM.
member-info Enter the keywords member-info to display the group index used by the ecmp,
the number of egress ports (members) for the ecmp, and the port details of each
member.
The detail information under member-info gives the MAC address, VLAN ID, and
gateway of every member port of the ecmp.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prefixes and
the total number routes which can be entered in to CAM.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip cam command shown in the following example.
Field Description
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP) available for the default
route for non-Jumbo line cards. For Jumbo line cards, displays 0,1 when ECMP is
more than eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is forwarded to the
CP or RP2, depending on Egress port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the entry to determine the
interface. For example, in the entry 17cl CP, the CP is the pertinent portion.
● CP = control processor
● Gi = Gigabit Ethernet interface
● Te = 10–Gigabit Ethernet interface
Example
Dell#show ip cam stack-unit 0 port-set 0 10.10.10.10/32 longer-prefixes
Destination EC CG V C VId Mac-Addr Port
----------------- -- -- - ------ --------------------
10.10.10.10 0 0 1 1 0 00:00:00:00:00:00 3f01 CP
Dell#
Usage
Information
The following describes the show ip cam ecmp-group command shown in the following example.
Field Description
Prefix Length Displays the prefix-length or mask for the IP address configured on the linecard 0
port pipe 0.
560 IPv4 Routing