White Papers

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(2.0P1) Introduced the description and port-id options.
Usage
Information
If you do not specify the option, by default the port-id takes higher precedence and sends the port-id in
the LLDP packets.
advertise management-tlv
Advertise management TLVs (Type, Length, Value).
Syntax
advertise management-tlv {system-capabilities | system-description |
system-name}
To remove advertised management TLVs, use the no advertise management-tlv {system-
capabilities | system-description | system-name} command.
Parameters
system-
capabilities
Enter the keywords system-capabilities to advertise the system capabilities
TLVs to the LLDP peer.
system-
description
Enter the keywords system-description to advertise the system description
TLVs to the LLDP peer.
system-name Enter the keywords system-name to advertise the system name TLVs to the
LLDP peer.
Defaults none
Command Modes CONFIGURATION (conf-lldp)
Supported Modes
Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.16.1 Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The command options system-capabilities, system-description, and system-name can be
invoked individually or together, in any sequence.
clear lldp counters
Clear LLDP transmitting and receiving counters for all physical interfaces or a specific physical interface.
Syntax
clear lldp counters interface
Parameters
interface Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet followed by the slot/port information.
Defaults none
Command Modes EXEC Privilege
750 Link Layer Discovery Protocol (LLDP)