API Guide

Debugging and Diagnostics
The basic debugging and diagnostic commands are supported by the Dell EMC Networking OS.
Topics:
• Diagnostics and Monitoring Commands
• Offline Diagnostic Commands
• Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the Control and Monitoring chapter.
logging coredump stack-unit
Enable coredump on a stack.
Syntax
logging coredump stack-unit {stack-unit-number | all}
Parameters
stack-unit stack-
unit-number
Enter the stack-unit id to enable coredump in a particular stack-unit.
all Enable coredump on all stack-unit.
Defaults Enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON and the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
The Kernel core dump can be large and may take up to 5 to 30 minutes to upload. Dell EMC Networking
OS does not overwrite application core dumps so you should delete them as necessary to conserve space
on the flash; if the flash is out of memory, the coredump is aborted. On the S-Series, if the FTP server
12
470 Debugging and Diagnostics