CLI Guide

Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0
to 4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON,
S3100, S6010-ON, S3048-ON, and C9010.
Usage
Information
The router with the largest value assigned to an interface becomes the designated router. If two
interfaces contain the same designated router priority value, the interface with the largest interface IP
address becomes the designated router.
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds command.
Parameters
seconds Enter a number as the number of seconds between router query messages. The
range is from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON,
S3100, S6010-ON, S3048-ON, and C9010.
ipv6 pim rp-address
Configure a static PIM rendezvous point (RP) address for a group. First-hop routers use this address to send register packets
on behalf of the source multicast host.
Syntax
ipv6 pim [vrf vrf-name] rp-address address {group-address group-address
mask} [override]
To remove an RP address, use the no ipv6 pim re-address address group-address mask
[override] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view IP
PIM debugging messages corresponding to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
address Enter the IPv6 RP address in the x:x:x:x::x format.
1216 PIM-Sparse Mode (PIM-SM)