CLI Guide

To disable the SSH server configuration, use the no ip ssh server vrf {management | vrf-
name} command.
Parameters
any Enter the keyword any to enable access to the server from any VRF.
vrf management Enter the keyword vrf followed by the keyword management to configure an
SSH server on a management VRF.
vrf vrf-name Enter the keyword vrf followed by the VRF name to configure an SSH server on
that VRF.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage
Information
You can enable the SSH server on either a management VRF or a user defined VRF but not both. If no
VRF is specified, then the SSH server is enabled on the default VRF.
If the SSH server is enabled on a VRF with name vrf1, then use the following command to restart the SSH
server on a VRF with name vrf2: ip ssh server vrf vrf2. If the SSH server is enabled on a VRF
with name vrf1, then use the following command to restart the SSH server on the default VRF: ip ssh
server vrf.
Example
• DellEMC(conf)# ip ssh server vrf any
• DellEMC(conf)# no ip ssh server vrf
• DellEMC(conf)# ip ssh server vrf vrf1
• DellEMC(conf)# no ip ssh server vrf
• DellEMC(conf)# ip ssh server vrf management
• DellEMC(conf)# no ip ssh server vrf
Related
Commands
● show ip ssh — displays the ssh information.
ip ssh source-interface
Specifies an interface’s IP address as the source IP address for an outgoing SSH connections.
Syntax
ip ssh source-interface interface
To delete a source interface, use the no ip ssh source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
1442 Security