CLI Guide

Example
DellEMC#show vxlan vxlan-instance 1 logical-network
Instance : 1
Total LN count : 1
Name VNID
bffc3be0-13e6-4745-9f6b-0bcbc5877f01 4656
DellEMC#$n-instance 1 logical-network n 2a8d5d19-8845-4365-
ad04-243f0b6df252
Name : 2a8d5d19-8845-4365-ad04-243f0b6df252
Description :
Tunnel Key : 2
VFI : 28674
Unknown Multicast MAC Tunnels:
192.168.122.133 : vxlan_over_ipv4 (up)
Port Vlan Bindings:
Te 1/16: VLAN: 2 (0x80000001),
Fo 1/49: VLAN: 2 (0x80000004),
Related
Commands
vxlan-instance — Enable VXLAN Instance configuration on the platform.
show vxlan vxlan-instance physical-locator
Displays physical locators related to Network Virtualization Overlay (NVO) Gateway.
Syntax
show vxlan vxlan-instance instance ID physical—locator [vtep-ip A.B.C.D]
Parameters
instance ID Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the
initial release.
A.B.C.D Enter the IP address of the VTEP.
Defaults Disabled
Command Modes VXLAN INSTANCE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced the static mode on the S4048–ON, S4048T-ON, S6000–ON, S6010–
ON, S6100–ON, and Z9100–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.10(0.1P10) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S6000.
Example
DellEMC#show vxlan vxlan-instance 1 physical-locator
Instance : 1
Tunnel : count 1
36.1.1.1 : vxlan_over_ipv4 (up)
Related
Commands
vxlan-instance — Enable VXLAN Instance configuration on the platform.
1710 Virtual Extensible LAN (VXLAN)