CLI Guide

Usage
Information
If you have configured the hello interval value to be greater than 18000, you must first reset that value to
be less than or equal to 18000 before upload. Otherwise, the command execution fails during bootup and
the hello interval value is set to the default value.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
NOTE: The IGMP query-max-resp-time value must be less than the IGMP query-interval value.
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time command.
Parameters
seconds Enter the number of seconds for the maximum response time. The range is from 1
to 25. The default is 10 seconds.
Defaults 10 seconds
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the system to
act as an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the system to
act as an IGMP Proxy Querier.
E-Series legacy
command.
Internet Group Management Protocol (IGMP) 661