Concept Guide

Configuring Monitor Multicast Queue
To configure monitor QoS multicast queue ID, use the following commands.
1. Configure monitor QoS multicast queue ID.
CONFIGURATION mode
monitor multicast-queue queue-id
DellEMC(conf)#monitor multicast-queue 7
2. Verify information about monitor configurations.
EXEC mode
EXEC Privilege mode
show run monitor session
DellEMC#show run monitor session
!
monitor multicast-queue 7
DellEMC#
Flow-Based Monitoring
Flow-based monitoring conserves bandwidth by monitoring only the specified traffic instead of all traffic on the interface. It
is available for Layer 3 ingress traffic. You can specify the traffic that needs to be monitored using standard or extended
access-lists. The flow-based monitoring mechanism copies packets that matches the ACL rules applied on the port and forwards
(mirrors) them to another port. The source port is the monitored port (MD) and the destination port is the monitoring port
(MG).
When a packet arrives at a port that is being monitored, the packet is validated against the configured ACL rules. If the packet
matches an ACL rule, the system examines the corresponding flow processor to perform the action specified for that port. If the
mirroring action is set in the flow processor entry, the destination port details, to which the mirrored information must be sent,
are sent to the destination port.
Behavior of Flow-Based Monitoring
You can activate flow-based monitoring for a monitoring session using the flow-based enable command in the Monitor
Session mode. When you enable this flow-based monitoring, traffic with particular flows that are traversing through the
interfaces are examined in accordance with the applied ACLs. By default, flow-based monitoring is not enabled.
There are two ways in which you can enable flow-based monitoring in Dell EMC Networking OS. You can create an ACL and
apply that ACL either to an interface that needs to be monitored or apply it in the monitor session context. If you apply the
monitor ACL to an interface, the Dell EMC Networking OS mirrors the ingress traffic with an implicit deny applied at the end of
the ACL. If you apply the ACL to the monitor section context, the Dell EMC Networking OS mirrors the ingress traffic with an
implicit permit applied at the end of the ACL. This enables the other traffic to flow without being blocked by the ACL.
When you apply an ACL within the monitor session, it is applied to all source interfaces configured in the monitor session.
The Dell EMC Networking OS honors any permit or deny actions of the ACL rules used for flow-based mirroring. Packets that
match a mirror ACL rule is denied or forwarded depending on the rule but the packet is mirrored. However, the user ACL has
precedence over the mirror ACL.
The same source interface can be part of multiple monitor sessions.
Flow-based monitoring is supported for SPAN, RSPAN, and ERSPAN sessions. If there are overlapping rules between ACLs
applied on different monitor sessions, the session with the highest monitor session ID takes precedence.
NOTE: You can apply only IPv4 ACL rules under monitor session context.
You must specify the monitor option with the permit, deny, or seq command for ACLs that are assigned to the source
or the monitored port (MD) to enable the evaluation and replication of traffic that is traversing to the destination port. Enter
the keyword monitor with the seq, permit, or deny command for the ACL rules to allow or drop IPv4, IPv6, ARP, UDP,
Port Monitoring
647