Connectivity Guide

If green profile is applied, default yellow also take effect and vice-versa.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.1.1.1 Introduced on the E-Series.
Usage
Information
Use the default pre-defined profiles or configure your own profile. You cannot delete the pre-defined
profiles or their default values. This command enables WRED configuration mode —(conf-wred).
Related
Commands
● threshold — specifies the minimum and maximum threshold values of the WRED profile.
rate shape
Define the rate-shaping method to be either as a measure of bytes or packets for each of the hierarchical QoS (HQoS) nodes at
the leaf level to be applied to each queue.
Syntax
[no] rate-shape [kbps | pps] peak-rate [burst-KB/Packets] [committed [kbps
| pps] committed-rate [burst-KB/Packets]]
Parameters
kbps Enter the keyword kbps to specify the committed rate limit in Kilobits per second
(Kbps). Specify this value as a multiple of 64. The range is from 0 to 40000000.
The default granularity is Megabits per second (Mbps).
pps Enter the keyword pps to specify the committed rate limit in packets per second
(pps). The range is from 1 to 268000000. The default granularity is Megabits per
second (Mbps).
committed-rate Define the committed rate, which is the guaranteed or minimum confirmed rate for
the packets. Specify this value as a multiple of 64 if you specify the committed rate
in Kbps. The range is from 0 to 40000000. The range is from 1 to 268000000 for
pps. The range is from 0 to 40000 for Mbps (which is the default measure for rate
limits if you do not explicitly configure Kbps or pps)
burst-KB (OPTIONAL) Enter the committed burst size in KB. The range is from 0 to 10000.
The default is 50 KB. The default peak burst is regarded as the same value as the
configured committed burst size.
1202 Quality of Service (QoS)