Connectivity Guide

Example
Dell(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
key innerL3header udf-id 6 packetbase innerL3Header offset 0 length 2
match l2ethertype ipv4 ipprotocol 4 vlantag any
!
udf-qualifier-value ipnip_val1
Dell(conf-udf-tcam)#
udf-id
Assign value for each configured UDF ID in the given UDF TCAM profile.
Syntax
udf-id id value mask
To return to the default settings, use the no udf-id 1-12 value mask command.
Parameters
id Enter the UDF ID range. The range is from 1 to 12.
value Enter the value for the UDF in Hex, up to 24 bytes.
mask Enter the mask for the UDF in Hex, up to 24 bytes.
Defaults None
Command Modes CONFIGURATION-UDF-Qualifier-Value Profile
Example
Dell(conf-udf-tcam-qual-val)#udf-id 1 aa ff
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500.
Related
Commands
udf-qualifier-value — creates a UDF qualifier value.
udf-tcam — creates a context for UDF TCAM.
show config — displays the current UDF -Qualifier-Value Profile configuration.
udf-qualifier-value
Create a UDF qualifier value to assign values for all UDF IDs.
Syntax
udf-qualifier-value name
To return to the default settings, use the no udf-qualifier-value name command.
Parameters
name Enter the UDF qualifier value profile name, up to 64 characters.
Defaults None
Command Modes CONFIGURATION-UDF TCAM
Example
Dell(conf-udf-tcam)# udf-qualifier-value ipnip_val1
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
266 Access Control Lists (ACL)