Connectivity Guide

NOTE: In Dell EMC Networking OS, the stack unit number and interfaces start from 0. But in Dell EMC Networking OS
Open Networking platforms, the stack unit number and interfaces start from 1.
The prompt changes to include the designated interface and slot/port number. For example:
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-
list standard command or the ip access-list extended command.
To enter IP ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter either the ip access-list standard command or the ip access-list extended command. Include a
name for the ACL. The prompt changes to include conf-std-nacl or conf-ext-nacl.
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see Intermediate System to
Intermediate System (IS-IS).
To enter ISIS ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER ISIS mode.
2. Enter the address-family ipv6 unicast command. The prompt changes to include conf-router_isis-
af_ipv6.
LLDP Mode
To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, see Link Layer Discovery
Protocol (LLDP).
To enter LLDP mode:
1. To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an interface, verify
that you are logged in to INTERFACE mode.
2. Enter the protocol lldp command. The prompt changes to include conf-lldp or conf-if-interface-lldp.
LLDP MANAGEMENT INTERFACE Mode
To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP MANAGEMENT
INTERFACE mode.
To enter LLDP MANAGEMENT INTERFACE mode:
1. Verify that you are logged in to LLDP mode.
2. Enter the management-interface command. The prompt changes to include conf-lldp-mgmtIf.
LINE Mode
To configure the console or virtual terminal parameters, use LINE mode.
To enter LINE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the line command. Include the keywords console or vty and their line number available on the switch. The prompt
changes to include config-line-console or config-line-vty.
You can exit this mode by using the exit command.
50
CLI Basics