Deployment Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810
8.5.1.0 Added support for 4-port 40G line cards.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To enable this snmp-server trap-source command, configure an IP address on the interface and
enable the interface configured as an SNMP trap source.
Related
Commands
● snmp-server community — sets the community string.
snmp-server user
Configure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port
port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password]
[priv {des56 | aes128} priv password] [access access-list-name | ipv6
access-list-name | access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name
remote ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5
| sha} auth-password] [priv {des56 | aes128} priv password] [access access-
list-name | ipv6 access-list-name | access-list-name ipv6 access-list-name]
command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that
connects to the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The
following groups are created for mapping to read/write community/security-names
(defaults):
● v1v2creadu — maps to a community with ro permissions.
● 1v2cwriteu — maps to a community rw permissions.
remote ip-
address
Enter the keywords udp-port then the user datagram protocol (UDP) port
number on the remote device. The range is from 0 to 65535. The default is 162.
1480 Simple Network Management Protocol (SNMP) and Syslog