Developers Guide

match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
NOTE: IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-any class-maps on both
ACLs as well as VLANs.
Syntax
[seq sequence number] match ip access-group access-group-name [set-ip-dscp
value | set-color value]
To remove ACL match criteria from a class map, use the no [seq sequence number] match
ip access-group access-group-name [set-ip-dscp value | set-color value]
command.
Parameters
seq sequence
number
(OPTIONAL) Enter the keyword seq then the sequence number. The range is from
1 to 100. By default, the sequence number are assigned in multiples of five.
access-group-
name
Enter the ACL name whose contents are used as the match criteria in determining
if packets belong to the class the class-map specifies.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The
matched traffic is marked with the DSCP value. The range is from 0 to 63.
set-color value (Optional) Enter the keyword set-color followed by a color value. Traffic that fulfills
the match criteria is marked with the color value that you specify. The default value
is Yellow.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the seq option for the class-map on all the Dell EMC Networking OS
platforms.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the DSCP Marking option support on the S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series; added support for the DSCP Marking option.
6.1.1.1 Introduced on the E-Series.
1224 Quality of Service (QoS)