Developers Guide

sflow collector
Configure a collector device to which sFlow datagrams are forwarded.
Syntax
sflow collector {ip-address | ipv6-address} agent-addr {ip-address | ipv6-
address} [number [max-datagram-size number]] | [max-datagram-size number]
[vrf management]
To delete a configured collector, use the no sflow collector {ip-address | ipv6-
address} agent-addr {ipv4-address | ipv6-address} [number [max-datagram-
size number]] | [max-datagram-size number] [vrf management] command.
Parameters
sflow collector
ip-address |
ipv6-address
Enter the IP address of the collector in dotted decimal format for IPv4 or x:x:x:x::x
format for IPv6.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
agent-addr ip-
address | ipv6-
address
Enter the keyword agent-addr followed by the sFlow agent IP address in dotted
decimal format for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
number (OPTIONAL) Enter the user datagram protocol (UDP) port number. The range is
from 0 to 65535. The default is 6343.
max-datagram-
size number
(OPTIONAL) Enter the keyword max-datagram-size then the size number in bytes.
The range is from 400 to 1500. The default is 1400.
vrf management (OPTIONAL) Enter the keyword vrf followed by the keyword management
to configure the collector device corresponding to the default VRF and the
management VRF respectively.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.4.2.3 Added support for IPv6 sFlow collectors and agents on the E-series, C-Series, and
S-Series.
8.4.1.1 Added support for IPv6 sFlow collectors and agents on the E-series.
8.3.7.0 Introduced on the S4810.
1436 sFlow