Developers Guide

● auto: configures the port to operate using the DCBX version received from a
peer.
● cee: configures the port to use CDD (Intel 1.01).
● cin: configures the port to use Cisco-Intel-Nuova (DCBX 1.0).
NOTE: For CIN, priority-group/traffic-class group wise bandwidth works
and priority wise bandwidth configuration is ignored.
● ieee-v2: configures the port to use IEEE 802.1az (Draft 2.5).
Defaults Auto
Command Modes INTERFACE PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the
DCBX configuration on a port, use the show interface dcbx detail command.
debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt |
resource | sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng |
fail | mgmt |
resource | sem |
tlv}
Enter the type of debugging, where:
● all: enables all DCBX debugging operations.
● auto-detect-timer: enables traces for DCBX auto-detect timers.
● config-exchng: enables traces for DCBX configuration exchanges.
● fail: enables traces for DCBX failures.
● mgmt: enables traces for DCBX management frames.
● resource: enables traces for DCBX system resource frames.
● sem: enables traces for the DCBX state machine.
● tlv: enables traces for DCBX TLVs.
Defaults None
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
484 Data Center Bridging (DCB)