Glossary
If the timer expires and an object’s state has changed, a notification is sent to the client. If no delay is
configured, a notification is sent immediately after a change in the state of a tracked object is detected.
The time delay in communicating a state change is specified in seconds.
Related
Commands
● track interface ip routing – configure object tracking on the routing status of an IPv4 Layer 3
interface.
● track interface line-protocol – configure object tracking on the line-protocol state of a Layer 2
interface.
● track ip route metric threshold – configure object tracking on the threshold of an IPv4 route metric.
● track ip route reachability – configure object tracking on the reachability of an IPv4 route.
description
Enter a description of a tracked object.
Syntax
description {text}
To remove the description, use the no description {text} command.
Parameters
text
Enter a description to identify a tracked object (80 characters maximum).
Defaults None
Command Modes OBJECT TRACKING (conf_track_object-id)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Related
Commands
● track interface ip routing – configure object tracking on the routing status of an IPv4 Layer 3
interface.
● track interface line-protocol – configure object tracking on the line-protocol state of a Layer 2
interface.
● track ip route metric threshold – configure object tracking on the threshold of an IPv4 route metric.
● track ip route reachability – configure object tracking on the reachability of a specific IP address.
Policy-based Routing uses the track command to track the next-hop ip address.
show running-config track
Display the current configuration of tracked objects.
Syntax
show running-config track [object-id]
1094 Object Tracking