Glossary

ManualsBrandsDell ManualsAccess PlatformsOS9

1771

To re-enable a disabled VRRP group, use the no disable command.

Command Modes VRRP

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage

Information

To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command

and enter no disable.

Commands

● virtual-address — specify the IP address of the virtual router.

hold-time

Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP

MASTER, the new switch can stabilize its routing tables.

Syntax

hold-time {seconds | centisecs centisecs}

To return to the default value, use the no hold-time command.

Parameters

seconds

Enter the number of seconds. The range is from 0 to 65535. The default is zero

(0) seconds.

centisecs

Enter the keyword centisecs then the number of centisecs in units of 25

centisecs. The range is from 0 to 65525 in units of 25 centisecs.

Defaults zero (0) seconds or (0) centiseconds