Install Guide

rpf RPF table
DellEMC#
Displaying an IPv6 Interface Information
To view the IPv6 configuration for a specific interface, use the following command.
● Show the currently running configuration for the specified interface.
EXEC mode
show ipv6 interface interface {slot/port}
Enter the keyword interface then the type of interface and slot/port information:
○ For all brief summary of IPv6 status and configuration, enter the keyword brief.
○ For all IPv6 configured interfaces, enter the keyword configured.
○ For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
○ For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
○ For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
○ For a port channel interface, enter the keywords port-channel then a number.
○ For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
DellEMC#show ipv6 int ManagementEthernet 1/1
ManagementEthernet 1/1 is up, line protocol is up
IPV6 is enabled
Stateless address autoconfiguration is enabled
Link Local address: fe80::201:e8ff:fe8b:386e
Global Unicast address(es):
Actual address is 400::201:e8ff:fe8b:386e, subnet is 400::/64
Actual address is 412::201:e8ff:fe8b:386e, subnet is 412::/64
Virtual-IP IPv6 address is not set
Received Prefix(es):
400::/64 onlink autoconfig
Valid lifetime: 2592000, Preferred lifetime: 604800
Advertised by: fe80::201:e8ff:fe8b:3166
412::/64 onlink autoconfig
Valid lifetime: 2592000, Preferred lifetime: 604800
Advertised by: fe80::201:e8ff:fe8b:3166
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::1:ff8b:386e
ND MTU is 0
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 3
ND reachable time is 32000 milliseconds
ND base reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
ND hop limit is 64
Showing IPv6 Routes
To view the global IPv6 routing information, use the following command.
● Show IPv6 routing information for the specified route type.
EXEC mode
show ipv6 route [vrf vrf-name] type
The following keywords are available:
○ To display information about a network, enter ipv6 address (X:X:X:X::X).
○ To display information about a host, enter hostname.
○ To display information about all IPv6 routes (including non-active routes), enter all.
444
IPv6 Routing