Service Manual

Object Tracking
Object Tracking supports IPv4 and IPv6, and is available on the Dell EMC Networking platforms.
Object tracking allows you to define objects of interest, monitor their state, and report to a client when a change in an object’s
state occurs. The following tracked objects are supported:
● Link status of Layer 2 interfaces
● Routing status of Layer 3 interfaces (IPv4 and IPv6)
● Reachability of IPv4 and IPv6 routes
● Metric thresholds of IPv4 and IPv6 routes
You can configure client applications, such virtual router redundancy protocol (VRRP), to receive a notification when the state
of a tracked object changes.
Topics:
• IPv4 Object Tracking Commands
• IPv6 Object Tracking Commands
IPv4 Object Tracking Commands
The following section describes the IPv4 VRRP commands.
debug track
Enables debugging for tracked objects.
Syntax
debug track [all | notifications | object-id]
Parameters
all Enables debugging on the state and notifications of all tracked objects.
notifications Enables debugging on the notifications of all tracked objects.
object-id Enables debugging on the state and notifications of the specified tracked object.
The range is 1 to 500.
Defaults Enable debugging on the state and notifications of all tracked objects (debug track all).
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
37
1018 Object Tracking