Setup Guide

Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the DSCP Marking option support on the S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series; added support for the DSCP Marking option.
6.1.1.1 Introduced on the E-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is identified, you can
configure the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed.
For class-map match-all, only one ACL match criteria is allowed.
Related
Commands
● class-map — identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
Syntax
[seq sequence number] match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-
dscp value]
To remove a DSCP value as a match criteria, use the no [seq sequence number] match {ip |
ipv6 | ip-any} dscp dscp-list [[multicast] set-ip-dscp value] command.
Parameters
seq sequence
number
(OPTIONAL) Enter the keyword seq then the sequence number. The range is from
1 to 100. By default, the sequence number are assigned in multiples of five.
ip Enter the keyword ip to support IPv4 traffic.
ipv6 Enter the keyword ipv6 to support IPv6 traffic.
ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
dscp-list Enter the IP DSCP values that is to be the match criteria. Separate values by
commas — no spaces ( 1,2,3 ) or indicate a list of values separated by a hyphen
(1-3). The range is from 0 to 63.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The
matched traffic is marked with the DSCP value. The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
1158 Quality of Service (QoS)