Setup Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1551

Table Of Contents

This delay restore timer applies only during reload/boot-up and not in other

scenarios (for example, during ICL flap).

Defaults 60 seconds

Command Modes VLT DOMAIN

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4820T, S4810, S6000, S5000, Z9000, S6000–ON and Z9500.

Usage

Information

To abort the VLT delay restore timer value as the maximum threshold, during reload, apply the maximum

time interval to the hold-down ICL peer-up in the start-up configurations.

lacp ungroup member-independent

Prevent possible loop during the VLT peer switch bootup or on a device that accesses the VLT domain.

Syntax

lacp ungroup member-independent {vlt | port-channel}

Parameters

vlt Force all VLT LACP members to become switchports.

port-channel Force all LACP port-channel members to become switchports.

Defaults Not configured.

Command Modes CONFIGURATION