Setup Guide

timers bgp extended
Adjust the BGP idle holdtime for all the BGP neighbors.
Syntax
timers bgp extended idle-holdtime
To return to the default, use the no timers bgp extended command.
Parameters
extended idle-
holdtime
Enter a number for the time interval, in seconds, for the peer to be idle state. The
range is from 1 to 32767. The default is 15 seconds.
Defaults
The default idle-holdtime is 15 seconds.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the C9010, MXL, FN IOM, S3100 series, S3048–ON, S4048–ON,
S4048T-ON, S5048F-ON, S6000, S6010–ON, S6100–ON, Z9100–ON, Z9500, and
S6000–ON.
Usage
Information
The peer remains in idle state based on the configured idle-holdtime. The less the idle-holdtime,
lesser the peer in idle state.
For the new idle-holdtime to take effect, you need to shutdown all the peers manually using neighbor
shutdown command and enable the peers again.
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the internet and connecting
multicast topologies between BGP and autonomous systems (ASs).
Dell EMC Networking OS MBGP is implemented as per IETF RFC 1858.
BGPv4 is supported in the following:
Dell EMC
Networking
OS Version
Platform Support
7.8.1.0, MBGP
for IPv4
Multicast Only
S-Series
debug ip bgp dampening
View information on routes being dampened.
Syntax
debug ip bgp [vrf vrf-name] [ipv4 {unicast | multicast} | ipv6 unicast]
dampening
To disable debugging, use the no debug ip bgp dampening command.
Border Gateway Protocol 421