Setup Guide

Example
Dell#show system stack-unit 1 quad-port-profile
Configured fan out profile ports in stack-unit 1
Configured Activated
2 2
4 4
6 6
8 8
9 9
10 10
11 11
12 12
13 13
14 14
15 15
16 16
17 17
18 18
19 19
20 20
21 21
22 22
23 23
24 24
26 26
28 28
30 30
32 32
stack-unit 1 quad-port-profile
2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,26,28,30,32
Related
Commands
stack-unit portmode — splits a single 40G port into four-10G ports
stack-unit portmode quad
Configures the list of dynamic fan-out capable ports.
Syntax
stack-unit [stack-unit number] port port-number portmode quad
To remove the quad-port configuration, use the command.
Parameters
Defaults 2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,26,28,30,32
Command Modes CONFIGURATION
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.7(0.0) Introduced on the S6000 and S6000–ON.
Usage
Information
The default quad port profile configuration includes all ports except the top four left ports and the
top four right ports in the switch. As a result, you cannot fan-out these switch ports using the stack-
unit stack-unit-number portmode command when the ports are in the default quad port profile
configuration.
You can change this default quad port profile configuration using the stack-unit stack-unit-
number port port-numbers portmode quad command and include the top four left ports and
top four right ports in your new profile. When you change the default profile, you can dynamically fan-out
the ports that are part of the new profile using the stack-unit stack-unit-number portmode
quad command.
Interfaces 643