Setup Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
To configure a shortcut name that you can use instead of entering a long string of numbers associated
with an NSAP address, use this command.
Related
Commands
● hostname dynamic — enable dynamic learning of host names from routers in the domain and allows
the routers to advertise the host names in LSPs.
debug isis
Enable debugging for all IS-IS operations.
Syntax
debug isis
To disable debugging of IS-IS, use the no debug isis command.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Entering debug isis enables all debugging parameters.
To display all debugging information in one output, use this command. To turn off debugging, you normally
enter separate no forms of each command. To disable all debug messages for IS-IS at once, enter the no
debug isis command.
Intermediate System to Intermediate System (IS-IS) 751