Setup Guide

• show processes memory
• show reset-reason
• show software ifm
• show system
• show tech-support
• ssh-peer-stack-unit
• telnet
• telnet-peer-stack-unit
• terminal length
• traceroute
• undebug all
• virtual-ip
• write
banner exec
Configure a message that is displayed when your enter EXEC mode.
Syntax
banner exec c line c
To delete a banner, use the no banner exec command.
Parameters
c Enter the keywords banner exec, then enter a character delineator, represented
here by the letter c. Press ENTER.
line Enter a text string for your banner message ending the message with your
delineator. In the following example, the delineator is a percent character (%); the
banner message is “testing, testing”.
Defaults No banner is displayed.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
80 Control and Monitoring