White Papers

debug ip msdp
Turn on MSDP debugging.
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address | packet peer
address | pim} command.
Parameters
event peer
address
Enter the keyword event then the peer address in a dotted decimal format
(A.B.C.D.).
packet peer
address
Enter the keyword packet then the peer address in a dotted decimal format
(A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Defaults Not configured.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.2.1.1 Introduced
ip msdp cache-rejected-sa
Enable an MSDP cache for the rejected source-active entries.
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-rejected-sa
{number} command then the ip msdp cache-rejected-sa {number} command.
Parameters
number Enter the number of rejected SA entries to cache. The range is from 0 to 32766.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
1012 Multicast Source Discovery Protocol (MSDP)