White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

1661

Table Of Contents

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.9(0.0) Introduced on the C9010.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.3(0.0) Introduced on the S6000, S4810, S4820T, Z9000.

Usage

Information

This command configures the method used to set the high 6 bits (the differentiated services codepoint)

of the IPv4 TOS or the IPv6 traffic class in the outer IP header.

A value of 0 copies original packet DSCP (IPv4)/Traffic Class (IPv6) to the tunnel header DSCP (IPv4)/

Traffic Class (IPv6) depending on the mode of tunnel.

tunnel flow-label

Configure the method to set the IPv6 flow label value in the outer tunnel header.

Syntax

tunnel flow-label value

To return to the default value of 0, use the no tunnel flow-label value command.

Parameters

value

Enter a value to set the IPv6 flow label value in the tunnel header. The range is

from 0 to 1048575. The default value is 0.

Defaults 0 (Mapped original packet flow-label value to tunnel header flow-label value)

Command Modes INTERFACE TUNNEL (conf-if-tu)

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.