White Papers

%TSM-6-SFM_DISCOVERY: Found 9 SFMs
%CHMGR-5-CHECKIN: Checkin from line card 5 (type EX1YB, 1 ports)
%TSM-6-PORT_CONFIG: Port link status for LC 5 => portpipe 0: OK portpipe 1: N/A
%CHMGR-5-LINECARDUP: Line card 5 is up
%CHMGR-5-CHECKIN: Checkin from line card 12 (type S12YC12, 12 ports)
%TSM-6-PORT_CONFIG: Port link status for LC 12 => portpipe 0: OK portpipe 1: N/A
%CHMGR-5-LINECARDUP: Line card 12 is up
%IFMGR-5-CSTATE_UP: changed interface Physical state to up: So 12/8
%IFMGR-5-CSTATE_DN: changed interface Physical state to down: So 12/8
To view any changes made, use the show running-config logging command in EXEC privilege mode, as shown in the
example for Configuring a UNIX Logging Facility Level.
Configuring a UNIX Logging Facility Level
You can save system log messages with a UNIX system logging facility.
To configure a UNIX logging facility level, use the following command.
● Specify one of the following parameters.
CONFIGURATION mode
logging facility [facility-type]
○ auth (for authorization messages)
○ cron (for system scheduler messages)
○ daemon (for system daemons)
○ kern (for kernel messages)
○ local0 (for local use)
○ local1 (for local use)
○ local2 (for local use)
○ local3 (for local use)
○ local4 (for local use)
○ local5 (for local use)
○ local6 (for local use)
○ local7 (for local use)
○ lpr (for line printer system messages)
○ mail (for mail system messages)
○ news (for USENET news messages)
○ sys9 (system use)
○ sys10 (system use)
○ sys11 (system use)
○ sys12 (system use)
○ sys13 (system use)
○ sys14 (system use)
○ syslog (for syslog messages)
○ user (for user programs)
○ uucp (UNIX to UNIX copy protocol)
To view non default settings, use the show running-config logging command in EXEC mode.
Dell#show running-config logging
!
logging buffered 524288 debugging
service timestamps log datetime msec
service timestamps debug datetime msec
!
logging trap debugging
logging facility user
logging source-interface Loopback 0
logging 10.10.10.4
Dell#
72
Management