White Papers

dot1p3_group-
num
dot1p4_group-
num
dot1p5_group-
num
dot1p6_group-
num
dot1p7_group-
num
Defaults None
Command Modes DCB MAP
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
Usage
Information
PFC and ETS settings are not pre-configured on Ethernet ports. You must use the dcb-map command to
configure different groups of 802.1p priorities with PFC and ETS settings.
Using the priority-pgid command, you assign each 802.1p priority to one priority group. A priority
group consists of 802.1p priority values that are grouped together for similar bandwidth allocation and
scheduling, and that share latency and loss requirements. All 802.1p priorities mapped to the same queue
must be in the same priority group. For example, the priority-pgid 0 0 0 1 2 4 4 4 command
creates the following groups of 802.1p priority traffic:
● Priority group 0 contains traffic with dot1p priorities 0, 1, and 2.
● Priority group 1 contains traffic with dot1p priority 3.
●
Priority group 2 contains traffic with dot1p priority 4.
● Priority group 4 contains traffic with dot1p priority 5, 6, and 7.
To remove a priority-pgid configuration from a DCB map, enter the no priority-pgid command.
Related
Commands
priority-group bandwidth pfc— Configures the ETS bandwidth allocation and the PFC setting used to
manage the port traffic in an 802.1p priority group.
qos-policy-output ets
To configure the ETS bandwidth allocation and scheduling for priority traffic, create a QoS output policy.
Syntax
qos-policy-output policy-name ets
To remove the QoS output policy, use the no qos-policy-output ets command.
Parameters
policy-name Enter the policy name. The maximum is 32 characters.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
112 Data Center Bridging (DCB)