White Papers

Parameters
value Enter the timeout value in seconds. The range is from 1 to 65535. The default value
is 0 (no timeout).
Command Modes VLT DOMAIN (conf-vlt-domain)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the IPV6/IPV4 support on the MXL.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When the timer expires, the software checks to see if the VLT peer is now available. If the VLT peer is
not available, peer-routing is disabled on that peer.
primary-priority
Reconfigure the primary role of VLT peer switches.
Syntax
primary-priority value
Parameters
value To configure the primary role on a VLT peer, enter a lower value than the priority
value of the remote peer. The range is from 1 to 65535.
Default 32768
Command Modes VLT DOMAIN
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
After you configure the VLT domain on each peer switch on both sides of the interconnect trunk, by
default, the software elects a primary and secondary VLT peer device. To reconfigure the primary role of
VLT peer switches, use the priority command.
show ip mroute
View the multicast routing table.
Syntax
show ip mroute [static | group-address [source-address] | count | snooping
[vlan vlan-id] [group-address [source-address]] | summary | vlt [group-
address | count]
Parameters
Static (OPTIONAL) Enter the keyword static to view static multicast routes.
group-address
[source-address]
(OPTIONAL) Enter the multicast group-address to view only routes associated with
that group.
Enter the source-address to view routes with that group-address and source-
address.
count (OPTIONAL) Enter the keyword count to view the number of multicast routes and
packets.
snooping [vlan
vlan-id ] [ group-
(OPTIONAL)
1178 Virtual Link Trunking (VLT)