White Papers

Usage
Information
Entering a no debug ip bgp command removes all configured debug commands for BGP.
Related
Commands
show ip bgp ipv6 unicast dampened-paths — views BGP dampened routes.
debug ip bgp ipv6 unicast soft-reconfiguration
Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast
soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-
group-name] ipv6 unicast soft-reconfiguration command.
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor on which you want to enable soft-
reconfiguration debugging.
peer-group-name Enter the name of the peer group on which you want to enable soft-
reconfiguration debugging.
ipv6 unicast Debug soft reconfiguration for IPv6 unicast routes.
Defaults Disabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast routes. If no
neighbor is specified, debug is turned on for all neighbors.
Related
Commands
show ip bgp ipv6 unicast dampened-paths — views BGP dampened routes.
debug ip bgp keepalives
Allows you to view information about BGP keepalive messages.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] keepalives [in |
out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-
name] keepalives [in | out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prefix length
in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group then the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only inbound keepalive messages.
out (OPTIONAL) Enter the keyword out to view only outbound keepalive messages.
Command Modes EXEC Privilege
IPv6 Border Gateway Protocol (IPv6 BGP) 611