White Papers

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4.0.0 Added support for the RPM / ERPM.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC# show monitor session 1
SessID Source Destination Dir Mode Source IP
Dest IP DSCP TTL Drop Rate Gre-Protocol FcMonitor
------ ------ ----------- --- ---- ---------
-------- ---- --- ---- ---- ----------- ---------
1 Gi 1/45 Gi 1/46 tx Port 0.0.0.0
0.0.0.0 0 0 No N/A N/A yes
DellEMC#
DellEMC# show monitor session
SessID Source Destination Dir Mode Source IP Dest
IP DSCP TTL Drop Rate Gre-Protocol FcMonitor
---- ------ ----------- --- ---- ---------
-------- ---- --- ---- ---- ----------- ---------
0 Te 1/50 Te 1/51 rx Port 0.0.0.0
0.0.0.0 0 0 No N/A N/A yes
1 Gi 1/45 Gi 1/46 tx Port 0.0.0.0
0.0.0.0 0 0 No N/A N/A yes
DellEMC#
Example (show
monitor session
access-list)
The following is an example output of the show monitor session access-list command.
DellEMC#sho monitor session 13 access-list
Monitor session – 13
Interface Direction Mirror-access-list
--------- --------- ------------------
Gi 1/1/1/1 rx mtacl
mtv6acl(ipv6)
Related
Commands
● monitor session — creates a monitoring session.
● rate-limit — configures the rate-limit.
show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show running-config
monitor session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range from 0 to 65535.
Port Monitoring 1183