White Papers

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or
copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and these blocks
cannot be reallocated. The ipv4acl profile range is from 1 to 8.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The
ipv6acl allocation must be a factor of .
If you enabled BMP, to perform a reload on the chassis to upgrade any configuration changes that have
changed the NVRAM content, use the reload conditional nvram-cfg-change command.
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
Syntax
cam-acl-vlan {default | vlanopenflow {0|1}}
Defaults Disabled.
Parameters
default Reset VLAN CAM ACL entries to default settings
vlanopenflow Enter the number 1 to allocate VFP blocks and enable OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.1.(0.0) Introduced on S4810.
8.3.19.0 Introduced on the S4820T.
Usage
Information
Reboot the switch after changing the parameter values for changes to take effect.
For platform-specific instructions about using this command, see the SDN section of the Dell EMC
Networking OS Configuration Guide.
88 Control and Monitoring