White Papers

● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port-channel interface, enter the keywords port-channel then the
port-channel ID.
in | out | both Enter the keyword in, out, or both to debug incoming interfaces, outgoing
interfaces, or both incoming and outgoing interfaces.
vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is from 1 to 4094.
count value Enter the keyword count then the number of debug outputs. The range is from 1
to 100.
Defaults Debug disabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series, and E-Series.
7.4.1.0 Introduced
protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
Syntax
protocol-tunnel {rate-limit rate| stp}
To disable protocol tunneling for a Layer 2 protocol, use the no protocol-tunnel command.
Parameters
rate-limit rate Enter the keyword rate-limit followed by a number for the rate-limit for
tunneled packets on the VMAN. The range is from 64 to 320.
stp Enter the keyword stp to enable protocol tunneling on a spanning tree, including
STP, MSTP, RSTP, and PVST.
Service Provider Bridging 1443