API Guide

Defaults seconds = 10; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Hello packets are held for a length of three times the value of the hello interval. To conserve bandwidth
and CPU usage, use a high hello interval seconds. Use a low hello interval seconds for faster convergence
(but uses more bandwidth and CPU resources).
Related
Commands
● isis hello-multiplier — specify the number of IS-IS hello packets a neighbor must miss before the
router declares the adjacency as down.
isis hello-multiplier
Specify the number of IS-IS hello packets a neighbor must miss before the router declares the adjacency down.
Syntax
isis hello-multiplier multiplier [level-1 | level-2]
To return to the default values, use the no isis hello-multiplier [multiplier] [level-1
| level-2] command.
Parameters
multiplier Specifies an integer that sets the multiplier for the hello holding time. Never
configure a hello-multiplier lower than the default (3). The range is from 3 to 1000.
The default is 3.
level-1 (OPTIONAL) Select this value to configure the hello multiplier independently for
Level 1 adjacencies. This value is the default.
level-2 (OPTONAL) Select this value to configure the hello multiplier independently for
Level 2 adjacencies.
Defaults multiplier = 3; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
834 Intermediate System to Intermediate System (IS-IS)