CLI Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
6.1.1.0 Added support for the VLAN interface.
ip pim dr-priority
Change the designated router (DR) priority for the interface.
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0
to 4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series on port-channels and the S-Series.
Usage
Information
The router with the largest value assigned to an interface becomes the designated router. If two
interfaces contain the same designated router priority value, the interface with the largest interface IP
address becomes the designated router.
PIM-Sparse Mode (PIM-SM) 1177