CLI Guide

of-instance{ of-
id }
Enter the keyword of-instance then the OpenFlow instance ID to add the VLAN to
the specified OpenFlow instance. The range is from 1 to 8.
NOTE: Associate the OpenFlow instance with the VLAN when the VLAN is
created. An existing VLAN cannot be associated with an OpenFlow instance.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage
Information
For more information about VLANs and the commands to configure them, see Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs and IP ACLs are supported.
For more information, see Access Control Lists (ACL).
The following features are not supported on VLANs associated with an OpenFlow instance:
● IPv4
● IPv6
● MTU
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot be enabled
simultaneously.
Example (Single
Range)
DellEMC(conf)# int vlan 3
DellEMC(conf-if-vl-3)#
Related
Commands
● interface — configure a physical interface.
● interface loopback — configure a loopback interface.
● interface null — configure a null interface.
● interface port-channel — configure a port channel group.
● show vlan — display the current VLAN configuration on the switch.
● shutdown — disable/enable the VLAN.
● tagged — add a Layer 2 interface to a VLAN as a tagged interface.
● untagged — add a Layer 2 interface to a VLAN as an untagged interface.
Interfaces 681