Deployment Guide

Multicast
The multicast commands are supported by Dell Networking operating system.
This chapter contains the following sections:
● IPv4 Multicast Commands
NOTE: Dell Networking OS supports Multicast routing only on default VRFs .
Topics:
• IPv4 Multicast Commands
• IPv6 Multicast Commands
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree
information base, use the clear ip pim tib command.
C9000 Series
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[ source-address ]
Enter the multicast group address and source address (if desired), in dotted
decimal format, to clear information on a specific group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping route table entries.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2.(0.0) Added support for keyword snooping on the Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series.
E-Series legacy
command
33
1070 Multicast